![]() ![]() I haven't had the chance to check yet but that's simple enough, David advised me that most installation require the light to be aimed a little lower after installation. The diameter of the adapter ring is significantly larger than the diameter of the halogen bulb base so the retention bail take some work to fit, There are some supplemental instructions in the package but they aren't as helpful as a good video, Don't rely on the youtube video David at BestRest did for the install, with the redesign of the assembly it is no longer accurate. Turns out it was relatively easy to package all the electronics on the lo-beam side without affecting the ability to aim the reflector. I was on the cusp of packing them all up and sending them back but decided to check the fit of the halogen bulb that was taken out-it had to be snapped into place.so with a little more persuation the adapter popped into place and the lo-beam side was buttoned up. By this time the bike's been down for 10 days, I've finished the install of the Hexezcan and rewired the aux lights and I'm getting frustrated. Either the socket on the reflector was small or the adapter ring large. The lo-beam side initially wouldn't seat properly. A note on fitting the H7 adapter rings that come with the bulbs. Lo-beam arrived today and I finished the installation in a half-hour. It looks like there's more room for the lo-beam but I don't have it in hand yet so I can't comment yet. David provide a sheet of install mods with the bulbs but I can tell you it's a challenge getting the hi-beam installed and all the electronics properly packaged. It's about 3 inches long and it does not bend at all. Now the control unit is connected to the bulb connection with a 2-piece molded, 4-pin connector. The original design had the connectors wired straight into the control unit which made for a relatively easy installation. If you have looked at the install video he has posted on youtube you need to be aware that the design has changed. David at BestRest must have been having a bad week because he sent me mismatched bulbs for my 06.and then sent the replacement to himself.so I only have the hi-beam installed at this point. ![]() Second Cylops.after looking over the Chinese replacement headlamp assembly that some have used I was unhappy with the deletion of all the aiming hardware. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |